JQC-3F T73 DATASHEET PDF

By using our site, you acknowledge that you have read and understand our Cookie Policy , Privacy Policy , and our Terms of Service. Raspberry Pi Stack Exchange is a question and answer site for users and developers of hardware and software for Raspberry Pi. It only takes a minute to sign up. This source at raspberrypi. So there is no problem.

Author:Samuk Kajizahn
Country:Uganda
Language:English (Spanish)
Genre:Marketing
Published (Last):11 May 2007
Pages:455
PDF File Size:7.16 Mb
ePub File Size:17.76 Mb
ISBN:177-7-85431-862-1
Downloads:46162
Price:Free* [*Free Regsitration Required]
Uploader:Tami



Pages: [1]. Topic: Relay jqc-3f, connect to the arduino. Read times previous topic - next topic. Relay jqc-3f, connect to the arduino. Hi, I have a relay jqc-3f, for example, I need to using Arduino, enable or disable the propeller to operate from AC V.

I know that there are relay control modules, like DFRobot, but because of their high cost, would not like to use them because of the limited resource of the relay.

Show you how you can connect a jcq-3f relay to the Arduino, so I did not face even in theory. Thank you in advance! Re: Relay jqc-3f, connect to the arduino. It is clear that there is a version with two networks, one from Arduino, 5V, 12V other for relay control, and which operate using 12V transistor It's just not very convenient, because will have to make separate meals I would like everything to work on one power supply.

I have read that if Arduino submit 12V, and they will be available at the outlet, do not want to burn the card check this out No, don't apologise, but if you want sensible answers, post a Web link to the thing you are talking about. Link up manifnst of the relay. OK, so that is a series of relays available in different coil voltages, notably 5 V and 12 V. The 5 V relay would require 80 mA to operate, while the 12 V would require 30 mA.

Well, 80 mA is far too much for an Arduino pin to source 20 mA practical maximum and 12 V is too much for it to switch in any case. You need a general-purpose NPN transistor with its emitter to ground, it collector switching one side of the relay coil with the other side going to whatever voltage you need to power it, and the base supplied from an Arduino pin via a Ohm resistor. You also need a diode across the relay coil, anode to the transistor collector and cathode to the supply.

Thank you very much for your reply, I will try to do so. Just need to find a relay with 5 volts. Thank you, so clear, once again thank you for your help!

DSL HAUPTVERTEILER PDF

JQC-3F Datasheet

.

AREI REGLEMENT PDF

PCB Relay JQC-3F(T73)

.

Related Articles